Sunday, November 13, 2011

Comercial Float Chemical Light Install


 This is a pretty simple install all you need is a chemical light stick, 4 1oz egg sinkers, two drill bits, a drill, and a hammer. The drill bit for the chem light needs to be slightly smaller then the light. Same goes for the lead.
 
Figure out where you want the top to be and drill about 1/4in deep with the small drill bit. Make sure you can put your chem light in securely.
Once you have your chem light hole drilled drill the hole for a keel. This is the part that will make the chem light stick above water. It needs to be on the opposite side of the float to work properly.
 Now hammer in your weights until flush and you are done.

No comments:

Post a Comment